Trane Performance Air Handlers Installationshandbuch PDF herunterladen (Seite 15)

CAH-SVX01B-EN 15

Installation - Mechanical

Lifting and Rigging

 WARNING

Heavy Objects!

Do not use cables (chains or slings) except as shown. Each of the cables (chains or slings) used

to lift the unit must be capable of supporting the entire weight of the unit. Lifting cables (chains

or slings) may not be of the same length. Adjust as necessary for even unit lift. Other lifting

arrangements may cause equipment or property-only damage. Failure to properly lift unit could

result in death or serious injury. See details below.

 WARNING

Heavy Objects!

Always place, assemble, and suspend sections/subassemblies one at a time. Do not lift units in

windy conditions. Do not raise units overhead with personnel below unit. Failure to follow these

instructions could result in death, serious injury, or equipment damage.

WARNING

 WARNING

Improper Unit Lift!

Test lift unit approximately 24 inches to verify proper center of gravity lift point. To avoid

dropping of unit, reposition lifting point if unit is not level. Failure to properly lift unit could

result in death or serious injury or possible equipment or property-only damage.

NOTICE

Equipment Damage!

Do not use a fork lift on air handlers or subassemblies. Improper use of fork lifts on units may

result in equipment damage. Trane is not responsible for equipment damage resulting from

improper forklifting practices.

Preparation of the roof curb or pier mount and roof openings should be completed before lifting

unit to the roof. Per job requirements, air handlers will ship as a complete assembly or in sections.

Trane recommends that the contractor use spreader bars and slings to rig units and sub-assemblies

(sections).

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 99 100

Keine Kommentare

Trane Performance Air Handlers Installationshandbuch Seite 15