Trane Modular 20 to 35 Tons Installationshandbuch PDF herunterladen (Seite 13)

CXRC-SVX01F-EN 13

Installation - Mechanical

Unit Handling Procedure

Lifting brackets are provided along the base rail on both

sides of the unit. Pass lifting cables through the 1. 5-inch

diameter holes in the brackets and install spreader bars

between the cables above unit. A label on the unit base rail

illustrates proper lifting procedure.When rigged properly,

the unit will balance at its center of gravity.

Perform a test lift to ensure balance, equilibrium and unit

level is maintained. Adjust rigging as required based on

initial test lift.Test adjusted rigging with second test lift.

Continue test lifting unit until satisfactory results are

obtained. Do not proceed with final lift until unit remains

static, level and stable during test lift. See Figure 12, p. 13.

Note: Maintain unit level throughout the lifting process or

structural damage may occur.

WARNING

Improper Unit Lift!

Test lift unit approximately 24 inches to verify proper

center of gravity lift point.To avoid dropping of unit,

reposition lifting point if unit is not level. Failure to

properly lift unit could result in unit dropping and

possibly crushing operator/technician which could

result in death or serious injury and possible

equipment or property-only damage.

Figure 12. Proper unit rigging and lifting procedure using spreader bars

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Keine Kommentare

Trane Modular 20 to 35 Tons Installationshandbuch Seite 13