August 2009PART-SVN122A-ENInstallationVariable Frequency Drive Conversion TR1 to TR200Commercial Self Contained Signature and Modular Series UnitsMode
10 PART-SVN122A-ENRemoval and Replacement for S**G Without Bypass1. Locate the existing TR1 VFD. It will most likely be mounted on a wall near the CS
PART-SVN122A-EN 11Removal and Replacement for S**G Without Bypass3. Disconnect the power and control wires from the VFD. WARNINGHeavy Objects!Do not
12 PART-SVN122A-ENRemoval and Replacement for S**G With Bypass1. Locate the existing TR1 VFD and bypass assembly. The VFD will be replaced; all compo
PART-SVN122A-EN 13Removal and Replacement for S**G With BypassFigure 8. Typical control wiring for S**G units with bypassTable 3. Typical wires for S*
14 PART-SVN122A-ENRemoval and Replacement for S**G With Bypass3. Remove the three (3) sheet metal parts (front cover, cover support bracket, and angl
PART-SVN122A-EN 15TR200 VFD Programming InformationThe following parameters must be programmed into the VFD prior to operation. Refer to BAS-SVX19A-EN
www.trane.comFor more information, contact your local Trane office or e-mail us at [email protected] Order Number PART-SVN122A-ENDate August
© 2009 Trane All rights reserved PART-SVN122A-ENWarnings, Cautions and NoticesWarnings, Cautions and Notices. Note that warnings, cautions and notice
PART-SVN122A-EN 3Warnings, Cautions and NoticesWARNING Personal Protective Equipment (PPE) Required!Installing/servicing this unit could result in ex
4 PART-SVN122A-ENTable of ContentsGeneral Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PART-SVN122A-EN 5General InformationAbout this ManualThe step-by-step instructions outlined in this manual describe the procedures required to success
6 PART-SVN122A-ENRemoval and Replacement for S**F Units1. Locate the existing TR1 VFD in the VFD panel on the right front side of the CSC unit. The V
PART-SVN122A-EN 7Removal and Replacement for S**F Units3. Disconnect the power and control wires from the VFD.Figure 3. Typical control wiring for S**
8 PART-SVN122A-ENRemoval and Replacement for S**F Units WARNINGHeavy Objects!Do not use cables (chains or slings) except as shown. Each of the cable
PART-SVN122A-EN 9Removal and Replacement for S**F Units11. Reconnect the wiring to the TR200. The connection points on the TR200 VFD are the same as t
Kommentare zu diesen Handbüchern